Army

HQDA Guidance on implementation of Section compliance

MEMORANDUM FOR SEE DISTRIBUTION SUBJECT: Guidance for Implementation of Congressionally Mandated Requirements Concerning Access to Federal Information Technology by Members of the Public and Federal Employees with Disabilities (Section 508 of the Rehabilitation Act) 1. References. a. U.S. Access Board, Electronic and Information Technology Accessi  ... more>>

I Chose To Look The Other Way

I Chose To Look The Other Way I could have saved a life that day, But I chose to look the other way. It wasn't that I didn't care, I had the time, and I was there. But I didn't want to seem a fool, Or argue over a safety rule. I knew he'd done the job before, If I called it wrong, he might get sore. The chances didn't seem that bad, I've done the s  ... more>>

CRD-C 6432-01 Standard Test Methods for Compressive Strength of Masonry Prisms

CRD-C 643-01 Standard Test Methods for Compressive Strength of Masonry Prisms 1. Scope 1.1 These test methods cover two compression tests of masonry prisms: 1.1.1 Method A−For determining comparative data on the compressive strength of masonry built in the laboratory with either different masonry units or mortar types, or both. 1.1.2 Method B−For  ... more>>

Printable FSGA vehicle registration form

Method of Test for Coefficient of Thermal Expansion of Mortar

(Issued 1 June 1963) CRD-C 126-63 METHOD OF TEST FOR COEFFICIENT OF THERMAL EXPANSION OF MORTAR Scope 1. This test method covers the procedure for determining the coefficient of linear thermal expansion of mortars using an extensometer method. Apparatus 2. The apparatus used shall consist of: (a) A constant-temperature bath maintained at 140 ± 0.5  ... more>>

Standard Test Method for Tensile Strength of Hydraulic Cement Mortars

CRD-C 260-01 Standard Test Method for Tensile Strength of Hydraulic Cement Mortars 1. Scope 1.1 This test method covers the determination of the tensile strength of hydraulic cement mortar employing the briquet specimen. It is primarily for use by those interested in research on methods for determining tensile strength of hydraulic cement. 1.2 Thi  ... more>>

Standard Test Method for Flow Under Water of Hydraulic Cement Concrete

(Issued 1 Mar. 1984) CRD-C 32-84 STANDARD TEST METHOD FOR FLOW UNDER WATER OF HYDRAULIC-CEMENT CONCRETE 1. Scope 1.1 This method* covers the determination of the flow of concrete intended to be placed under water using a tremie. The test may be conducted in the laboratory or in the field. 1.2 The values stated in inch-pound units are to be regarded  ... more>>