Turn any paint into an insulating_ thermal barrier coating by suchenfz


									                          Poland European Distributor - www.adalio.eu           +48 691 745 445

                                        Turn any paint into an insulating, thermal
                                                     barrier coating

                                 CeraTherm is a fine powder blend of high strength ceramic
                                 micro spheres. Each sphere is barely thicker than a human
                                 hair. The ceramic spheres in CeraTherm have compressive
                                 strengths up to 6,000 psi, a softening point of about 1800° C.,
                                 and they are fairly chemical resistant, with low thermal
conductivity of 0.1 W / m / Deg.C. Through a technological process of removing any gasses
from inside the spheres we created a vacuum inside. Since nothing can travel by conduction
through a vacuum we create a thermal as well as sound barrier when painting with
CeraTherm additive.

                                        The painted surface dries to a tightly packed layer of
                                        hard and hollow micro spheres. The tightly packed film
                                        reflects and dissipates heat energy because ceramic
                                        spheres are able to reflect, refract and block heat
                                        radiation (loss or gain).

CeraTherm insulating additive is completely inert and can be mixed into ANY paint, coating or
composite including interior house paint, exterior house paint, roof paint, solvent base coating,
epoxy, urethane, high temperature paint, elastomerics, etc. The addition of the ceramic
spheres to any material provides improved fire resistance, protection of coated surfaces from
harmful UV rays, increased durability of the coating plus paint with CeraTherm is easier to
clean and lasts longer.
Poland European Distributor - www.adalio.eu   +48 691 745 445
                   Poland European Distributor - www.adalio.eu           +48 691 745 445

                                Additional Benefits

o Reduces heating or cooling losses!
o Longer lasting durability - you paint less often.
o Exceptional stain and scrub resistance
o Ceramics are Non-Toxic & Fire Resistant
o Helps dampen sound
o Use on Interior or Exterior
o Environmentally Friendly
o Improved resistance to corrosion, abrasion, mold and mildew

            Basic information about ceramics and their usage

o Ceramics can be mixed into ANY type of paint or coating. They have also been used
  successfully with powder coatings, stucco, plastics and composites, and many other
  types of material.
o Two coats are required for best distribution of the small spheres. Additional coats will
  provide better results.
o The painted surface will have a slight texture due to the spheres. This is a very fine
  texture and resembles suede. This slight texture is very effective at hiding small
  defects on the wall surface.
o Sheen levels in paints are reduced slightly due to the texture created. Flat paints are
  not affected.
o Ceramics are most effective at reflecting heat back to the source. For best results in
  summer...apply to the outside surfaces. For best results in winter...apply to the inside
o The addition of a Radiant Barrier coating as a first coat can improve results
o The ceramic product will not change the color of your paint. Only in some cases of
  very dark colors being used, has the shade of paint been lightened slightly. If this
  happens you simply apply a topcoat of the dark color with no ceramics added.
o Ceramics will last indefinitely if stored in a dry environment.
                   Poland European Distributor - www.adalio.eu            +48 691 745 445

                               Directions for Use

o Gradually stir the appropriate amount of additive into the container of paint. Use a
  second, larger container for mixing purposes. Make sure you completely mix the
  entire additive into your paint!
o Always stir your paint for a minute or two prior to commencing painting if the paint
  has been sitting for more than 2 hours since last used.
o Mixing ratio is 4 parts paint to 1 part Ceramic Additive
o Pre-packaged containers are for 1 gallon and 5 gallon containers of paint
o Bulk container - simply measure out a dose for each gallon of paint
  1 dose = 1 qt = 32 oz vol = 4 cups
o Note: Recommended Roller Size 1/2" to 3/4" nap depending on surface texture
o Paint Sprayers - remove all filters Tip Size .019 - .024 or larger
o 2 coats of paint containing CeraTherm are required to insure complete, uniform
  distribution of the insulating spheres
o NOTE: do not exceed 1 pint of water per gallon for reduction purposes


o CeraTherm additive is an environmentally friendly blend of non-toxic organic
  ceramic micro spheres.
o Inhalation of large amounts of this product in its free powdered state could cause
  respiratory irritation and a dust mask should be worn if working around large
  airborne concentrations of this product prior to mixing with paint.
o If eye irritation occurs, flush eyes with water and if problems persist consult a
                         Poland European Distributor - www.adalio.eu           +48 691 745 445

                                           R - Value

Currently there are no approved testing techniques for testing R value of paints with insulating
additives. ASTM (American Society for Testing and Materials does not approve any
“modified” testing procedures.

Information on the R-value testing rule can be found at the Government's website:

Example of a FTC complaint against false R-value claims::

FTC regulations and definitions of R-values are located here:
                           Poland European Distributor - www.adalio.eu                 +48 691 745 445

                                   CeraTherm Paint Additive
                                  Materials Safety Data Sheet

Product Identification:

Product name                                          CeraTherm Paint Additive
Producer                                              GVK IBES Co.
Address                                               PO Box 539 Webster MA 01570
Phone                                                 774-253-1776

TSCA and Other Chemical Name:

Clay Mixture (CAS 66402-68-4) 66402-68-4, listed on the TSCA (U.S.), CDSL (Canada), EINECS
(E.U.), AICS (Australia), KECI (Korea) and PICCS (Philippines).

Because of physical characteristics, the additive can be considered articles according to above listed
inventories, and therefore exempt from chemical registration requirements.

DOT Hazard Class                                      Not Applicable
DOT Shipping Name                                     Non-regulated article
The NAFTA Harmonized Tariff Code                      6815-99-4000.

Chemical and physical data:

Appearance & Odor                                     Dry white powder, odorless
Ingredients                                           Mixture - Ceramic Spheres

Fire, Explosion and Reactivity Hazard Data:

Flash Point (° F)                                     Noncombustible
Special Fire Fighting Procedures                      Not Applicable
Stability                                             Stable Conditions to Avoid - None known
Incompatibility (materials to avoid)                  None Known
Hazardous Decomposition Products                      None
Spills/ Disposal, Environmental Hazard                None Known.
Spillage                                              Sweep, scoop, or vacuum material
Waste Disposal Method                                 Landfill according to local, state and federal
                                                      regulations. Disposed material is not a RCRA
                                                      hazardous waste.
                            Poland European Distributor - www.adalio.eu                 +48 691 745 445

Health Hazard Data:

Eye Contact                                           Causes irritation. Skin Contact -May cause
                                                      dehydration and irritation
Inhalation                                            Causes irritation to respiratory tract
Chronic Hazards                                       No known chronic hazards. Not listed by OSHA,
                                                      NTP or IARC as a carcinogen.
Medical conditions aggravated by exposure             Asthma and lung diseases
First aid procedures                                  In case of contact immediately flush eyes with
                                                      plenty of water. Get medical attention if irritation
                                                      persists. If inhaled, remove to fresh air

Special Protection Information:

Respiratory protection                                Use NIOSH-certified dust respirator where dust
                                                      occurs. Observe OSHA regulations for respirator
                                                      use (29 CFR 1910.134)

Gloves                                                Cotton gloves are usually sufficient to protect
                                                      hands from irritation arising from handling this
Eye protection                                        Chemical goggles
Personal hygiene                                      Avoid breathing dust. Wash thoroughly after
Engineering control                                   Use with adequate ventilation

This product does not contain crystalline silica and is not listed on any of the following
regulatory lists - EPCRA
                            Poland European Distributor - www.adalio.eu                +48 691 745 445

                            Other Specialty Coating Products

Concrete Forming Aid Coating –
For protecting concrete forms and wooden floors on trailers, boxcars and hopper cars against
weathering and attack from water, oils, chemical and acid solutions. Will dramatically increase the life
of wooden forms and reduce waste in the process while dramatically reducing imperfections in the
poured concrete. The insulating ceramics help maintain a stable temperature and to prevent loss of
moisture during the curing process.

Radiant Barrier Coating –
Radiant Barrier Coating is a reflective aluminum and ceramic coating, radiant barrier / vapor retarder
coating. Ideal for use in attics to reduce attic heat gain. Provides an extremely effective wall vapor,
insulating barrier

Fire Resistant Cable Coating –
PVC, wire and cable coating

Fire Resistant Cable Plus Coating –
Multi functional Fire Resistant, rodent resistant cable coating

Acoustic Coating –
Latex base flat acoustical coating designed to reduce sound through ceilings and walls. Ideal for home
theater use, condos, apartments.

High Build Coating –
Thick rubber-like coating designed for maximum thermal reduction on high temperature pipes, storage
tanks, where maximum heat reduction properties are required.

Metal Shield Coating –
The ultimate coating for steel, automotive and marine use.
Stops Rust, Insulates, Deadens sound

High Build Sound Deadening Coating –
For interior speaker cabinets, automotive door panels and headliners, any place an extremely effective
sound deadening temperature coating is required.

Encapsulguard Coating –
Elastomeric acrylic encapsulating coating that provides an economical, effective and safe sealing of
lead base paints, asbestos materials and CCA lumber.
                            Poland European Distributor - www.adalio.eu                   +48 691 745 445

Hi Temp Coating –
A high temperature (1200 degrees F), bright aluminum multi use industrial coating.

FreeKote Coating –
A high-gloss, non-yellowing white coating designed for application from ambient to sub-freezing
temperatures. Interior Frozen Food Lockers Ice Cream Hardening Rooms, Deep Freeze Units Cold
Storage Facilities

Vapor Barrier Mastic –
Vapor barrier mastic is a fire resistant, flexible, tough and durable coating for all types of thermal
insulation in cold and dual temperature service. It is designed as a vapor barrier coating to seal fittings,
heating and cooling ducts, piping, equipment insulated with fibrous glass, polyurethane foam, duct
work cellular glass and other low temperature materials.

Insul Cool-Coating –
For any slopped roof with good water runoff.

Roof Guard Coating –
Designed for flat roofs that are prone to ponding water.

Permacoat Plus Coating –
Any roof, sloped or flat requiring a Class "A" Fire Rating!

Bus Kote Coating –
Bus & Recreational Vehicle Coating

Elasto-Clear Coating –
Clear elastomeric roof coating for shingles and shakes

Permaclear Coating –
Tough Acrylic Clear Gloss Sealer & Finish for Metal Surfaces, Masonry Surfaces, Skylights,
Greenhouses, Glass. Designed for "hard to stick to surfaces".

Shield-All Coating –
All purpose Acrylic Clear Waterproof Sealer - Seals and protects a wide range of surfaces including
wood, masonry, cement, floors, shingles...Soap and water cleanup

Super Seal Coating –
Clear Waterproof Sealer-High solids for long lasting protection on any surface, no waxes or silicones.
                            Poland European Distributor - www.adalio.eu                 +48 691 745 445

Cem Seal Coating –
Concrete hardener and dust proofing sealer for concrete surfaces

Elasto-Clear Coating –
Clear elastomeric sealer & finish. Elasto-Clear is a "rubber like" elastic clear coating designed for use
over elastomeric roof coatings to protect from dirt and staining. Ideal for use on wood construction and
log homes as it expands and contracts!

Acriflow Coating –
A special acrylic polymer resin used to reduce latex paint. When added to paint, Acriflow increases that
paints flow properties and durability. Now you can turn inexpensive paints into a "Premium Paint" with
Acriflow! Excellent for reducing paints when adding CeraTherm Insulating Paint Additive.

Anti-Graffiti Coating –
Clear protective coating that is easily cleaned after being vandalized with graffiti.

To top