Docstoc

How to Install Acme Series 57/58 Sliding Door Roller Assembly Hardware

Document Sample
How to Install Acme Series 57/58 Sliding Door Roller Assembly Hardware Powered By Docstoc
					http://www.allaboutdoors.com                                                         Published 7/19/2011


  How to Install Acme Series 57/58 Roller Assembly Sliding Door Hardware

               For Questions or Concerns, please refer to All About Doors & Windows
                                  http://www.allaboutdoors.com

Series 57/58 Roller Assembly Sliding Door Hardware is meant for 1-1/8 inch or thicker single sliding
or bi-parting doors weighing up to 250 pounds each. The Acme part has been discontinued, but part
#25061 on www.allaboutdoors.com is an available replacement.




STEP 1: Trim your track so it is 1-1/2 inches shorter than the entire width of the opening of the door to
allow for room to insert the four-wheel hangers.




                            All About Doors & Windows     |   1901 Cherry St.
http://www.allaboutdoors.com                                                         Published 7/19/2011




STEP 2: Screw track to header. On a pocket door, make sure when you install your track that you leave
the 1-1/2” clearance in the doorway, not in the pocket.




STEP 3: Insert four-wheel hangers into track with key slot facing the interior of the room.




STEP 4: Bore 2 holes, each 1/2 inch diameter by 1/4 inch deep in the top horizontal edge of the door.
Make these holes 3 inches from either end of door.




                            All About Doors & Windows     |   1901 Cherry St.
http://www.allaboutdoors.com                                                            Published 7/19/2011




STEP 5: Attach the top plates to the door, centering them directly over the newly-made holes and using
holes to secure the plates in place.




STEP 6: Thread the pendant bolt into the top plate adjusting nut. Attach the door to the hanger by
inserting the pendant bolt into the key slot in the hanger; rotate the pendant bolt 90 degrees to lock it
into position. Turn the top plate nut with a wrench to adjust the door vertically for plumb and height.




                             All About Doors & Windows      |   1901 Cherry St.
http://www.allaboutdoors.com                                                             Published 7/19/2011




              The staff at All About Doors & Windows spends a considerable amount of time
              creating articles and providing quality parts and hardware. We know you can find
              many of these products elsewhere and we appreciate your business. We thank you for
              your time and hope you will continue being a satisfied customer.




                            All About Doors & Windows       |   1901 Cherry St.

				
DOCUMENT INFO
Description: This is a guide to installing Acme series 57/58 rollers in a sliding door.