SPECIFICATION DATA SHEET
CEMIX TILE GROUT COARSE
CEMIX TILE GROUT COARSE is a cementitious grout Varies depending on tile size, depth and width of joints
designed for use with porous and vitreous tiles on 1 Kg of grout will cover approximately 1.1 m2 at 10 mm
interior or exterior walls and floors with joint width less joints. Refer to the coverage chart for more details.
than 5 – 12mm. The grout is shrinkage compensated
which can prevent cracking. It has wide range of colour Theoritical consumption on the size of tile
to match different tiles. Tile dimension (mm) Gap Consumption
length width thickness width (Kg/m2)
PREPARATION: 300 300 10 10 1.1
CEMIX TILE GROUT COARSE can be applied 1 day 300 300 20 10 2.3
after tiling. Before commencing grouting ensure the tile 450 450 12 10 0.9
adhesive has set firmly and the grout joints are clean 600 600 12 10 0.7
Dampen the joints with clean water before applying the
Technical Data 12 months in original sealed bags in dry storage.
Colour Wide range of colour
Max.aggregate size 1.0mm PACKAGING:
Pot Life: 30 minutes approx.at 20º C. CEMIX TILE GROUT COARSE is packed in 5kg, 10kg
Mixing ratio by weight: 1 kg of product: 0.180 Litres and 20kg bags.
Coverage: Refer to the chart for more
details CEMIX TILE GROUT COARSE is also available with an
Antimicrobial additive to resist mould and bacterial
Add clean water to a mixing container and slowly add For further information contact CEMIX Technical Sales.
the CEMIX TILE GROUT COARSE powder into the
water with continuous mixing until thick creamy paste DISCLAIMER Please Note: Recommendations and advice
consistency without lumps is achieved. The mixing ratio regarding the use of this product are to be taken as a guide only. Other
is 10 kg powder to 1.8 litres of water. Stir the mixture than as appears on this products packaging, CEMIX LTD. does not
give any warranty express or implied as to the suitability of this product
thoroughly for 5 minutes and let it stand for 5 minutes for
for your particular use, because the usage of this product is beyond the
the additives to dissolve , then mix again before use. For control of CEMIX LTD. If you need advice concerning the use of
grouting over timber floors or any other difficult surfaces suitability of this product for your particular application, please contact
where movement is expected , mix CEMIX TILE GROUT CEMIX LTD first. If this product is defective because of CEMIX LTD's
fault, please contact the supplier or CEMIX LTD. who will replace it at
COARSE with CEMIX TILE BOND LATEX instead of
Apply the mixed grout with a rubber float or squeegee
diagonally over the tiles. Allow the grout to dry for 15 –30
minutes depending on temperature and humidity, and
then use a wet cloth to clean the tiled surface.
19 Alfred Street Onehunga, Auckland, New Zealand | Tel: 09-636-1000 Fax: 09-636-0000
0800 ASK CEMIX | Email: firstname.lastname@example.org | www.cemix.co.nz