micro m2

HFX® micro M2 - Installation Guide 1 2 Please open first the 4 screws of the backpanel, then you can lift up the lid. Remove the DVD and HDD cage. Lift and pull the base sheet. 3 4 Put the slim slot-in optical drive on the cage. and attach the heatpipe adapters to the outer heatsinks. 5 6 Turn the base sheet of the cage with the drive around, and use the two shorter M2,5 screws to fasten the optical drive to the base sheet Screw the two longer M2,5 screws to the base sheet, and use the nuts to fasten them They will be used later to mount the card reader. 7 8 For mounting the 2.5” HDD you have to prepare the small plate with the hexagonal bolts. You should use the longer bolts by standard. Only if you want to install a thicker HDD, then please use the shorter bolts. Use the counter sunk head screws for fastening the hex bolts. Place your Harddisk on the plate, on the side without the hex bolts, and use the short screws to fasten it. Depending what harddisk your are installing different holes should be used. HFX® is a trademark of mCubed Information Technology GmbH. The design is patented. 3D Visuals and product design by 24H Product Design. www.hifiatx.com - office@mcubed-tech.com - mCubed Information Technology GmbH - Mollardgasse 85a/3/136 - 1060 Vienna - Austria 9 10 Use three screws to mount the small plate and HDD to the base sheet of the inner cage. Put the black plastik spacers on the screws for the card reader. 11 12 Take the cardreader out of its cage and use two small threads to fix it to the inner cage. Plug in the USB cable to the cardreader. Connect the front LEDs with the motherboard: red front LED (yellow + / red -) green front LED (black + / white -) 13 14 The “Sens” connector is not needed, but the automatic front connector detection has to be deactivated in Windows. Put the inner cage back into the case and put the acrylic glas on the optical drive. Make sure to fasten the screw holding the small acrylic part on the heatsink. Push the small acrylic part on the heatsink down while fastening the screw. 15 16 A HDD silent box can also be placed on top of the inner cage if the TV card is not too long. But there is only space for 1 single HDD or HDD silent box. You can mount the backpanel first by letting a distance for closing the lid. After closing the lid, please tighten the 4 screws of the backpanel. HFX® is a trademark of mCubed Information Technology GmbH. The design is patented. 3D Visuals and product design by 24H Product Design. www.hifiatx.com - office@mcubed-tech.com - mCubed Information Technology GmbH - Mollardgasse 85a/3/136 - 1060 Vienna - Austria