MATERIAL SAFETY DATA SHEET
1 FIRE HAZARD 4 SEVERE
0 HEALTH HAZARD 2 MODERATE
ORIGINAL 0 REACTIVITY 0 MINIMAL
PRODUCT: Jewellery rubber molding compound in strips
Manufacturer: Alplas Polymers
Address: Unit No 4,Sheetal Indl.Estate No 6
Navghar Road,Vasai Road East Thane
Date Prepared :
Emergency: : (95250)2391986
Prepared by: : Mr.L.M. Nikam
SECTION 2- HAZARDOUS INGREDIANTS/IDENTITY INFORMATION
Components: Chemical nature & Common Names (Hazardous
components 0.05% or greater, carcinogen 0.05% or
Hazardous ingredients: 0%
This product is not a hazardous chemical.
Actual formula is a trade secret. Details
available to qualified medical personnel in
Non-hazardous Ingredients: Natural rubber & inorganic fillers-100%
SECTION 3- PHYSICAL/CHEMICAL CHARACTORISTICS
Boiling point: N/A
Vapor Pressure (mm
Hg and Temperature): N/A
Vapor Density (Air =1): N/A
Melting point: N/A
Evaporation Rate: N/A
Solubility in water: Insoluble.
Specific Gravity (H2O=1): Approximately 1.38 I 0.2
Appearance and Odor: Solid, approximately 0.125” thick, distinctive pleasant
Water reactive No.
SECTION 4- FIRE AND EXPLOSION HAZARD DATA
Auto-ignition Temperature: N/A
In Air & by volume: N/A
Extinguisher Media: Water, dry chemical, co2, foam, etc.
Unusual Fire and
Explosion Hazards: None. When exposed to flame, emits characteristic acrid
fumes. Will not self-ignite but will burn if exposed to
flame. As with any organic material, may emit carbon
dioxide and/ or carbon monoxide during combustion
depending upon conditions.
SECTION 5- REACTIVITY HAZARD DATA
Conditions to Avoid : None.
(materials to avoid): None.
Decomposition Products: None Known.
Hazardous Polymerization: Will not occur.
Conditions to avoid: None Known.
SECTION 6- HEALTH HAZARD DATA
Primary Routes of Entry: Non Hazardous
Carcinogen Listed in: Not Listed
Health Hazards: Acute: None
Signs & symptoms
Of Exposure: None.
Medical conditions generally aggravated by exposure: None Known
Eye Contact: None
Skin Contact: None.
SECTION 7- PRECAUTIONS FOR SAFE HANDLING AND USE/ LEAK
Steps to be taken if material
Is spilled or released: Return to container.
Waste disposal methods: Comply with local and state regulations.
Precautions to be taken
In handling and storage: None
Other Precautions and
/ or specific Hazards: None.
SECTION 8- CONTROL AND PROTECTIVE MEASURES
(Specify type): None needed.
Protection Gloves: None needed.
Eye Protection: None needed.
Ventilation to be used: Exhaust fan
Clothing and Equipment: None needed.
Hygienic Work Practices: None.
is the registered trademark of ALPLAS POLYMERS. Any
misrepresentation and misuse of the same is punishable offence.
SHOLAX® molding rubber is warranted for workability provided it is used properly. ALPLAS POLYMERS
however does not warranty either implied or expressed for any loss caused due to improper usage or
wrong/faulty tools used during the process of mold-making. The responsibility of ALPLAS POLYMERS is
strictly limited to the exchange of goods if informed in writing to the company within 30 days of the
receipt of the material.