INSTALLATION FOR BDL BALL BEARING LOCK UP CLUTCH BPP100-500-700 1 by gdf57j

VIEWS: 90 PAGES: 2

									                                     INSTALLATION FOR BDL BALL BEARING LOCK UP CLUTCH
                                     BPP100-500-700




BPP-100 BDL pressure plate with 32       Place BDL diaphragm over ball       Place BDL retainer over diaphragm and
-3/8” chromium steel ball bearings and   bearings on pressure plate.         insert shoulder bolts.
special adjustment screw and nut.




Holding assembly with pressure           While firmly holding assembly       Tighten shoulder bolts down to
against the diaphragm so that the        on clutch basket, locate holes in   approx. 25 TO 30 foot pounds.
ball bearings are secured, place         the clutch hub and screw the
assembly on to clutch basket.            shoulder bolts in.




                                                                                                                     1
BPP-700 Lock up for Primo belt   Place BDL diaphragm over ball       BPP-500 Lock up for HD 1998-2007
drives 1990-2007.                bearings then use Primo retainer,   BDL pressure plate with 45- 5/16”
Pressure plate with 42-5/16 “    adjustment screw and bolts and      chromium steel ball bearings.
chromium steel ball bearings.    install assembly onto Primo         Install with stock HD diaphragm,
                                 clutch basket using procedure       retainer and bolts and install as per
                                 outlined above. Re-adjust clutch    HD manual. Re-adjust clutch as per
                                 per Primo instructions.             HD manual.




                                                                                                             2

								
To top