DEPOSITION ENHANCEMENT - DRIFT REDUCTION
Water Dispersible Polymer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 75%
30 lb. EZ Stor
Constituents ineffective as spray adjuvant . . . . . . . . . . . . . . . . . . 25%
GENERAL DESCRIPTION SHROUD II USE RATES ADDITION THROUGH EDUCTOR
SHROUD II is a renewable bio-polymer in • 10 to 12 ounces per 100 gallons of spray • Fill tank at least half full with water
granular form that will enhance spray deposition mixture • Begin water flow through eductor system
and reduce drift of glyphosate and most other • 32 ounces (2 LB) per 51 pound bag of and maximum tank agitation
pesticide formulations. Sprayable Ammonium Sulfate • Add Shroud II to eductor funnel
SHROUD II was formulated to meet the • Allow dry Shroud II to flow into spray tank
increasing need for improved “on target” deposi- Spray Tank SHROUD II SHROUD II • Rinse funnel with water
tion of agricultural chemicals. Shroud II is highly Mix Total Rate to Rate to • Add additional water to tank as needed
compatible and readily dispersible into water. Gallons Add in Lbs. Add in Oz. • Maintain agitation for 1-2 minutes before
100 0.75 12 adding other chemicals to tank
FEATURES 200 1.50 24
• Rapid Dispersion in water 300 2.25 36
• Low-Foaming - specifically formulated to ADDING SHROUD II INTO
400 3.00 48 SPRAYABLE AMMONIUM SULFATE
reduce foam in the mixing tank 500 3.75 60
• Reduces “Bounce” of spray liquid from Add 1 to 2 lb. (32 oz.) of SHROUD II into a 51-
600 4.50 72
difficult to wet surfaces lb. bag of sprayable ammonium sulfate. While
700 5.25 84
• Increases Retention of large droplets by wearing rubber gloves, mix the SHROUD II into
800 6.00 96
grass weeds 900 6.75 108
the top few inches of the ammonium sulfate.
• Newtonian Behavior - no degradation due 1000 7.50 120 Determine rate of ammonium sulfate needed
to shear (i.e. 17 lb./100 gallon or 2.5 lb. per acre) After
• Dry Form - easy to store and handle-no filling the spray tank at least half full, add the
liquid spills to clean up Shroud II included bag of ammonium sulfate to
• Highly Compatible with most agricultural MIXING AND USE GUIDE the tank through either the top port or inductor.
chemicals Adding SHROUD II Directly into Tank Mixtures
Add additional water to tank as needed.
• Biodegradable - made from a renewable • Fill spray tank at least half full with water Maintain agitation for 1-2 minutes before adding
bio-polymer • Begin maximum tank agitation other chemicals to tank.
APPLICATIONS: SHROUD II can be used • Add SHROUD II to the tank through the REGULATORY: SHROUD II when used as directed
where agricultural chemical deposition enhance- top port or eductor system (see below) and in accordance with sound agricultural practices is in
ment or drift reduction is desired including use • A use rate of 10 to 12 oz. per 100 gallons compliance with EPA Regulations governing the crop-
with formulations of glyphosate and other salt of spray mixture is recommended. land use of adjuvants and is exempt from tolerance under
type crop protection chemicals formerly requiring
• Agitate tank for 1-2 minutes before Title 40, Code of Federal Regulations, 180.1001 (d).
SHROUD II can be used as a stand-alone prod- proceeding
uct or preblended with Ammonium Sulfate (AMS). • Add other chemicals and water to spray SAFETY INFORMATION: SHROUD II is a granular
Designed for but not limited to post emergence tank as desired product, which may irritate skin and eyes; handle
applications. • Continue tank agitation for 3-5 minutes accordingly. Chemical resistant gloves, goggles and
before spraying to ensure SHROUD II apron are recommended. The Material Safety Data
COMPATIBILITY: SHROUD II is not recommend- activation sheet should be reviewed prior to use.
ed for use with sprayable boron formulations such
as Solubor®, or with full strength high phosphorus ADDITION THROUGH TOP PORT HANDLING AND STORAGE: Keep product cool
fertilizers such as 10-34-0. • Fill tank at least half full with water and dry in sealed original containers. If a spill occurs,
the area may become slippery when wet. Do not
• Check for foam in tank
ADDITIONAL NOTES: SHROUD II is made from attempt to clean up spill with water because the result-
• If foam covers water surface, add
a polymer that is activated in spray mixtures by ing gel may be difficult to clean up. Sprinkle appropriate
water. The time required for activation is some- defoamer
absorbent over the spill area to minimize dusting and
what pH dependent. Although the polymer is acti- • Begin maximum agitation
sweep the material into approved chemical disposal
vated fastest at low (acidic) pH’s, it is desirable to • Slowly pour Shroud II into area of containers.
fully disperse Shroud II first in plain, neutral water maximum agitation
in the spray tank before adding acidic chemicals • Add additional water to tank as needed CLEANING OF EQUIPMENT: Spray equipment
or tank buffers. When Shroud II is added to high- • Maintain agitation for 1-2 minutes before should be thoroughly rinsed and flushed with a deter-
ly acidic tank mixtures, there is a greater chance adding other chemicals to tank gent in water solution. Obey all regulatory requirements
of polymer lumps forming if activation occurs
for disposal of pesticide solutions
faster than dispersion.
UNITED SUPPLIERS, INC.
Eldora, Iowa 50627 • 800-782-5123
CONDITIONS OF SALE OF WARRANTIES
The directions for use of these products reflect the opinion of experts based on field use and test. The directions are believed to be reliable and should be followed carefully. However, it is impossible to eliminate all risks inherently associated
with use of this product. Crop injury, ineffectiveness, or other unintended consequences may result because of such factors as weather conditions, presence of other materials, or the manner of use or application, all of which are beyond the con-
trol of the Manufacturer or the Seller. All such risks shall be assumed by the buyer. The manufacturer warrants that this product conforms to the chemical description on the label and is reasonably fit for the purposes referred to in the direc-
tions for use, subject to the inherent risks referred to above. THE MANUFACTURER OR SELLER MAKES NO OTHER EXPRESSED OR IMPLIED WARRANTY OF FITNESS OR MERCHANTABILITY OF ANY OTHER EXPRESSED OR IMPLIED WAR-
RANTY. IN NO CASE, SHALL SELLER BE LIABLE FOR CONSEQUENTIAL, SPECIAL OR INDIRECT DAMAGES RESULTING FROM THE USE OR HANDLING OF THIS PRODUCT. The Manufacturer and the Seller offer this product and the Buyer and
User accepts it subject to the foregoing conditions of sale and warranty which may be varied only by agreement in writing signed by duly authorized representative of the manufacturer.