c1 by msds

VIEWS: 6 PAGES: 2

									XEROX
Manufacturer:

MSDS No.:

C1 4/6/82

Material Safety Data Sheet
Xerox Corporation Rochester, N.Y. 14644

Date: Revision:

7/13/01 Telephone #’s Safety Information.: (800) 828-6571 Health Emergency: (716) 422-2177 Transportation Emergency(Chemtrec):(800) 424 - 9300

Section I - Product Identification
Trade Names/Synonyms: Chemical Name: WHMIS Status: 720/914/970/1000/1200/2400/ 3600/CFP/840EPS Photoreceptor None This is not a WHMIS controlled product. Ingredients Part No. 1R14, 1R17, 1R18,1R21, 1R23, 1R25, 1R35

CAS No. 7429-90-5

Substrate (>95%): Aluminum drum Coating (<5%): Selenium (>99%) Arsenic (<1%)

7782-49-2 7440-38-2

Section II - Emergency and First Aid
Primary Route of Entry: Skin Eyes: N.A. Skin: Wash with soap and water Inhalation: N.A. Ingestion: N.A.. Symptoms of Overexposure: None Medical Conditions Generally Aggravated by Exposure: None when used as described by product literature. Additional Information: None.

Section III - Toxicology and Health Information
This material has been evaluated by Xerox Corporation. Oral LD50: Dermal LD50: Inhalation LC50: Eye Irritation: Skin Sensitization: >5 g/kg (rats) practically non-toxic. >2 g/kg (rabbits) practically non-toxic. N.A. Not an irritant Not a sensitizer TLV: PEL: STEL: Ceiling: XEL1: 0.2 mg/m3 (selenium) 0.2 mg/m3 (arsenic) 0.2 mg/m3 (selenium) 0.01 mg/m3 (arsenic) N.E. N.E. 0.01 mg/m3 (arsenic) 0.05 mg/m3 (selenium)

Skin Irritation: Not an irritant. Human Patch: Non-irritating, non-sensitizing. Mutagenicity: Not tested. Carcinogens: See information below. Aquatic LC50:: >1000 mg/l (fathead minnows) non-toxic Additional Information: This product contains less than 1% arsenic which is classified as a carcinogen by NTP, IARC and OSHA.
1

.XEL - Xerox Exposure Limit N.A. - Not Applicable N.E. - None established N.D. - Not Determined

Page 1

Xerox
Appearance/Odor: Boiling Point: Solubility in Water: Evaporation Rate: Vapor Density (Air=1): Volatile:

Trade Name: 720/914/970/1000/1200/2400/3600/CFP/840EPS Photoreceptor

MSDS No: C1

Section IV - Physical Data
Solid/odorless N.A.. Insoluble N.A. N.A.. N.A. % (Wgt.) N.A. % (Vol.) Softening Range: Melting Point: Specific Gravity (H2O=1) Vapor Pressure (mm Hg): pH: N.A. N.A. N.A. N.A. N.A.

Section V - Fire and Explosion Data
Flash Point (Method Used): Extinguishing Media: Special Fire Fighting Procedures: Fire and Explosion Hazards: N.A. Flammable Limits LEL: UEL: N.A. N.A

Water, carbon dioxide, foam When in a machine, treat as an electrical fire. Exposure to high temperatures can result in melting and pyrolysis. Fumes may cause respiratory symptoms. Delayed effects may occur up to 72 hours.

Section VI - Reactivity Data
Stability: Hazardous Polymerization: Hazardous Decomposition Products: Incompatibility (Materials to Avoid): Stable Will Not Occur Oxides of selenium and arsenic. Strong acids

Section VII - Special Protection Information
. Respiratory Protection: Eye Protection: Protective Gloves: Other: None required when used as intended in Xerox equipment None required when used as intended in Xerox equipment None required when used as intended in Xerox equipment None required when used as intended in Xerox equipment

Section VIII - Special Precautions
Handling and Storage: Conditions to Avoid: Use wet pumicing and polishing procedures. Avoid exposure to high temperatures.

Section IX - Spill, Leak, and Disposal Procedures
For Spills or Leakage: Particles of coating detached through physical damage must be collected and disposed of as a chemical waste. Return used or damaged photoreceptor to Xerox Corporation or supplier. Under present EPA Regulations, it is not classified as a hazardous waste. Ensure conformity with federal, state and local regulations.

Waste Disposal Method:

Section X - Transportation Information
DOT Proper Shipping Name: Hazard Classification: N.A. (Not Regulated) N. A. ID Number: Packing Group: N. A. N. A.

Page 2


								
To top