Docstoc

Installing

Document Sample
Installing Powered By Docstoc
					Installing
– Insert lock cylinder into door handle.
– Clamp door handle in vise with protective pads.




  Attach mount -1-
– and coupling plate
  -2- on lock
  cylinder.




  Install torsion
  spring -1- into lock
– cylinder housing
  so that torsion
  spring end points
  toward rear.
  Position Assembly
  tool -T10009- with
–
  narrow slot -
  arrow- onto torsion
  spring -1-.




  Press down outer
  sleeve of
– Assembly tool -
  T10009- until it
  makes contact on
  mount -1-.
Assembly tool -
T10009- is depicted
with a cut-out
section to clarify
following assembly
steps.
  Turn Assembly
  tool -T10009- 180°
–
  toward right until
  slot -arrow- points
  toward front.
  Press down center
  rod -1- of
– Assembly tool -
  T10009-. Doing
  this compresses
  torsion spring.




  Torsion spring end
  springs out of slot
–
  in assembly tool
  and locks in
  mount.
  Now, carefully lift
– outer sleeve -1- of
  Assembly tool -
  T10009-.
Now center rod -2-
becomes visible,
which is slid over
lock cylinder.
  Lift Assembly tool
  -T10009- far
– enough until
  groove in lock
  cylinder becomes
  visible.
    Torsion spring -1-
–
    must be engaged
    in mount -arrow-.




  For assistance,
  torsion spring can
– be pushed into slot
  in lock cylinder
  using a low
  screwdriver.
– Remove assembly
  tool.
    Place paddle on
–
    torsion spring and
    press downward.
  Torsion spring
  disengages from
  slot in lock
– cylinder via
  circular motions
  and can be
  compressed
  further.
– Insert locking
  washer.




– Perform function
  test.

				
DOCUMENT INFO
Shared By:
Categories:
Stats:
views:17
posted:3/24/2011
language:English
pages:5