BOSTIK BATH SILICONE SEALANT TECHNICAL DATA SHEET DESCRIPTION TECHNICAL INFORMATION BOSTIK BATH SILICONE SEALANT is a fully waterproof, white sealant that resists Appearance : White homogeneous mildew. It gives a permanently flexible seal and will not crack or crumble. It paste o o withstands temperature extremes of -50 C to +150 C. Water Resistance : Excellent APPLICATIONS Skin over Time : Approx. 10 min. BOSTIK BATH SILICONE SEALANT is suitable for a variety of applications in and around the bathroom. It is ideal for sealing joints, gaps and cracks around baths and Curing Time : 24 hours per 2 mm sinks, repairs leaking plumbing and replacing tiles. Adheres to ceramics, metal, glass, Temperature tiles, painted surfaces and most plastics. range in service : -50oC to +150oC Slump DIRECTIONS FOR USE NF P 855016 : 0mm Surfaces must be clean and dry. Movement Accommodation 90 ml - Remove cap from tube and pierce film with reverse side of cap to break seal. Factor : 20% when cured Cut tip off nozzle to the desired bead size and screw nozzle onto tube. Squeeze tube and apply silicone at a slight angle in the direction of use. Bead Length After use, remove nozzle and replace cap firmly to avoid air entering the tube. Tube : 4 metres (5mm x 5mm joint) 310 ml - Cut tip off cartridge and screw nozzle onto cartridge. Cut tip of nozzle at an angle to desired bead size. Cartridge : 12 metres Apply silicone with a caulking gun in a continuous bead to prepared joint. (5mm x 5mm joint) Smooth after application (within 3 to 5 minutes) before skin formation by using a flat, Shelf life : 12 months in a wet instrument or finger - applying a little dishwashing liquid prevents sticking to skin. sealed cartridge. To Remove unwanted silicone immediately by wiping with a paper towel. prolong life of used Sealant “skins” in 10 minutes, dries to touch in 1 hour, reaches full cure after 24 hrs. cartridge, place piece On clothing, use a clean cloth, dampened with a non-flammable cleaning fluid or of plastic, over opening of cartridge paint thinners. Check colourfastness of fabric first. and screw nozzle When fully cured, sealant can be trimmed with a sharp knife. back on. During application, a vinegar odour will be noted - odour disappears as seal cures. Cleaning : Use of thinners is not recommended. NOTE: Cured silicone can If area to be filled requires painting, apply paint and allow to dry completely before only be removed by sealing Do not use on lead, copper, zinc, galvanised iron and tin Not suitable for mechanical means. alkaline surfaces such as cement, asbestos, concrete, plaster, etc. Will not adhere to PACKAGING some plastics Not suitable for fish tanks. 90 ml Tubes CAUTION: 310 ml Cartridges It is advisable to wear gloves in order to avoid contact with skin If skin or eye contact occurs, flush thoroughly with water If irritation continues, seek medical attention. KEEP OUT OF REACH OF CHILDREN.