; 126
Learning Center
Plans & pricing Sign in
Sign Out
Your Federal Quarterly Tax Payments are due April 15th Get Help Now >>



  • pg 1
									                                                                      TECHNICAL NOTE 126

                     SETUP AND USE OF VP 590 (Pin Tool Dryer)

   1. Locate pin tool dyer to base or robot deck.

   2. Register pin tool dryer to robot deck and make sure there is nothing obstructing the pin
      tool dryer.

Care and Use:

   1. The pin tool dryer can be used in two different ways.

          a. Press the side switch to the ON position to keep the pin the tool dryer on

          b. Press the side switch to the OFF position, so that the pin tool dryer is turned on
             when the top contact switch is triggered.

   2. If the pin tool dryer stops working, check the fuses next to the switch. The pin tool dryer
      uses two 5x20mm, 250mA 250V fuses. Access to the fuses can be achieved by first
      disconnecting the power chord, and using a screwdriver to pry open the fuse enclosure.

   3. Change the pin tool dryer filter every 2 to 3 months, depending upon use. The filter unit
      (VP 590A) must be pulled out of from the bottom of the pin tool dryer by carefully pulling
      the filter unit from the corners. Filter unit can be easily disassembled to access the
      carbon filter. Filter units (VP 590A) can be purchased from V&P Scientific, Inc.

               9823 Pacific Heights Boulevard, Suite T, San Diego, CA 92121
           (858) 455-0643 ● Fax: (858) 455-0703 ● email: sales@vp-scientific.com
V&P Scientific, Inc.   Technical Note 126

To top