Docstoc

Static Load Analysis Spreadsheet

Document Sample
Static Load Analysis Spreadsheet Powered By Docstoc
					CXT Selection Spreadsheet
                                       = enter value
     PARAMETER                                         COMMENT
bore (mm)                              example: 16
piston velocity Va(mm/s)               example: 300 (= stroke / time)
total weight of tooling (N)            example: 10
bearing type                           1-slide / 2-ball bushing
operating pressure (psig)              example: 70
cushion type                           1-adjust bolt with rubber bumper / 2-shock absorber

CUSHION TYPE IS ACCEPTABLE. PLEASE PROCEED TO THE NEXT STEP.


mounting orientation                   1-horizontal, upright
                                       2-horizontal, on side
                                       3-horizontal, upside down
                                       4-vertical
Center Of Mass location
X distance (mm)                   example: 10
Y distance (mm)                   example: 50
Z distance (mm)                   example: 100
       Distances are measured from the top-center of the slide block to the tooling center of mass.
       As shown below, X/Y/Z directions are in reference to the actuator, regardless of orientation.


                                                                                 LOAD RATES
                                                                               Static Load 0.0000
                                                                               Static Pitch 0.0000
                                                                               Static Yaw 0.0000
                                                                               Static Roll 0.0000
                                                                               Total ==> 0.0000




   Theoretical Force =        #####
   Resistance Force =           0.00   < 1/2 Maximum Theoretical Force ===> Acceptable Force
   Distance Formula =         #####
    Total Load Rate =          0.000   < 1.000 ===> Acceptable Load Rate

                   Final Analysis:        APPLICATION IS ACCEPTABLE!
center of the slide block to the tooling center of mass.
n reference to the actuator, regardless of orientation.

				
DOCUMENT INFO
Description: Static Load Analysis Spreadsheet document sample