Docstoc

How to Install a Car Audio Amplifier

Document Sample
How to Install a Car Audio Amplifier Powered By Docstoc
					How to Install a Car Audio Amplifier
Car audio amplifier is a tool that plays music inside a car. This
amplifier is not a built in tool. That means you will not get it while
buying a car. You have to buy it separately and have to install it in
your car. Installing this has some specific procedures. Here you will
some basic instructions about how to install a car audio amplifier.
First, you have to disconnect the terminals. This is not mandatory but
this is just for safety reason. Now, you have to run the power cable to
the amplifier from the battery. You have to find a ground point. It has
to be closer to the amplifier. Make sure that the point is attached to
the frame of the vehicle. The connection also has to be solid.
Run your power cable to the amplifier just as you have done with the
power cable. If your ground point has any color, then remove it. Use a
sandpaper to do this job. You can use it also to remove any rust. The
connection will not be solid if the metal is not shiny. If you want to
attach a ring terminal with the ground point, then this is the right time
to do that. After this you have to wrap up the ground point with
something that is non conducting. Then use some spray paint or any kind
of finish that will protect the ground point from rust.
Do not forget to turn on the remote and to run the RCA cables. You have
to pull out the head unit out of the mounting location. Fasten the remote
turn on wire with the wiring harness of the head unit. Now, decide which
amplifier will contain which RCA cable. Keep the RCA cables away from any
type of power cables. Keep them away especially from the amps power
cable.
Now, let all the wires of the speakers run. Fasten the wires with the
amplifier. After this turn the remote on and add the power to the ground.
Attach the fuse holder. Always attach it near the battery. If your
battery terminals are very sophisticated, then do not forget to give
proper protection and connect them in the right way. Attach the other
cables with the battery. It will be better if you can get your battery
terminals a brand new cover.
Before turning on the amplifier, check it properly. Turn the gain of the
amplifier down. After that turn your system on and listen carefully.
Check whether everything is working properly or not. Listen to the sound
carefully. Think whether you can hear any noise or not, and verify how
much noise you can hear. Verify whether there is any distortion exists
that is audible. If everything is completely all right, then move on to
the next step.
Your next step is to think how you will give power to the amp, where your
amp will stay, etc. With that your amplifier will be fixed perfectly. If
you follow all these steps then you will be able to install your
amplifier safely and properly.
Victor Epand is an expert consultant for used DVDs, used movies, and used
car stereos. You can find the best marketplace for used DVDs, used
movies, and used car stereos at these sites for used DVDs, used movies.

				
DOCUMENT INFO
Shared By:
Categories:
Stats:
views:9
posted:10/15/2010
language:English
pages:1