god tv

Document Sample
scope of work template
							GOD TV - TUNING INTO GOD TV ON A MULTICHOICE DECODER:
STEP #1
On your MultiChoice decoder, go to channel 99 and follow the simple instructions on
the TV screen to verify if you can upgrade your software.
NB: Older decoders that do NOT upgrade will NOT be able to receive God Channel.

STEP #2
Then follow the instructions below and you’ll be able to receive God Channel 24
hours a day, 7 days a week absolutely free!!!

1)     On your REMOTE CONTROL press the MENU button.
2)     Press 6 for ADVANCED OPTIONS.
3)     Press 1 for DISH INSTALLATIONS.
4)     Enter PIN Code: 9949
5)     Press 2 for NETWORK CONFIGURATION.
6)     Press 2 for NETWORK 2 SETUP. (If 2 is greyed out, use NETWORK 3 SETUP)
7)     On SIGNAL SETUP press OK to highlight DISABLED.
8)     Press ‘Right Arrow’ button (>) to change to ENABLED and press OK.
9)     Make sure #2 ‘ORBITAL POSITION’ is PAS7/10
10)    Make sure #3 ‘USE NIT’ is YES.
11)    Press 4 for FREQUENCY: (you may need to press OK before the next step).
12)    Press ‘Left Arrow’ button (<) 5 times.
13)    Enter 11170 and press OK to save.
14)    Press 5 for SYMBOL RATE: (you may need to press OK before next step).
15)    Press ‘Left Arrow’ button (<) 5 times.
16)    Enter 26652 and press OK to save.
17)    Make sure #6 ‘POLARISATION’ is VERTICAL.
18)    Press 7 for FEC: (you may need to press OK before next step).
19)    Press ‘Left Arrow’ button (<) 3 times until it reads 5/6.
20)    Press OK button to save.
21)    Press 8 to VIEW SIGNAL STRENGTH, then press OK button to save.
22)    When saved, press EXIT – one time only!
23)    Press 3 to SCAN NEW NETWORKS. (If 3 is greyed out, press 4)
24)    After scanning process complete, receiver may go to channel 1.
25)    Go to CHANNEL 4 which should be MOVIE MAGIC.

To watch God Channel:
1)     On your remote, press the TV button.
2)     Press the ‘Up Arrow’(^) button on your remote.
3)     Find and select PUBLIC PAS7/10 and press OK.
4)     Press P+ BUTTON ON YOUR REMOTE until you find God Channel

For DSTV press the TV button on your remote and select DSTV.

If you have the New DSTV upgrade software installed then from STEP 5 the panel
should have the following options set. It works the same as the above setting:

PTO
NEW DSTV Setting for GOD Channel

02. LNB Power        - ON
03. Mode             - DUAL
04. Low Frequency    - 9750
05. High Frequency   - 10700
06. Frequency        - 11170
07. Symbol Rate      - 26652
08. FEC              - 5/6
09. POLARISATION     - VERTICAL
10. NIT              - YES
11. ACCEPT

With these settings you will be able to view the following: - (Channel numbers
can vary)

Channel Name                                                    Channel No
TCT – Total Christian Television                                     16
Hope Channel                                                         18
Spirit Word – Kobus Van Rensburg                                     19
God TV                                                               36

						
Related docs