Installation Instructions and Template for 5K Dummy Trim - PDF

Document Sample
Installation Instructions and Template for 5K Dummy Trim - PDF Powered By Docstoc
					                                     Installation Instructions
                                     and Template for 5K Dummy Trim
Follow these instructions to install a 5K Dummy Trim Lever.                             4 Insert the machine screw through the washer and then through the
   Note: The 5K Dummy Trim Lever can only be installed onto one side of                   opposite side of the door.
   the door. Two dummy trim levers cannot be installed back-to-back                     5 Install the rose onto the liner so that it fits flush to the door face.
   unless the levers are positioned offset.                                             6 Tighten the lever onto the door

                                                                                        Template for 5K Dummy Trim
  1     Mark door and drill hole
   Note: Suggested height from floor to centerline of the dummy trim is
   40 5/16″ (1.024 m).
1 Cut out the Template for 5K Dummy Trim from this instruction and
  place it in position aligning the dashed line to the edge of the door.




                                                                                                                                        Drill 3/8"
                                                                                                                                        (9.5mm)
  See Figure 1.




                                                                                                                                        dia hole
                                                      Mark 3/8 inch
   Align the                                          (9.5mm) hole here
   dashed line of
   the template                                       Template
   to the edge of
   the door




                                                                                                              high edge of door bevel




                                                                                                                                                                              2 3/4" BACKSET (70 mm)
                                                                                                              Fold along the dashed




                                                                                                                                                     2 3/8" BACKSET (60 mm)
   Figure 1 Marking the door with the door template
                                                                                                              line and place on the
2 Mark the drill point.
3 Drill a 3/8″ (9.5mm) diameter hole through the door.

  2     Install trim
1 Remove the liner from the rose as shown in Figure 2.
2 Position the liner so that the center hole is aligned with the hole
  drilled into the door as shown in Figure 2.
3 Surface mount the liner to the door with the two wood screws
  as shown in Figure 2.

                                                                                             Figure 3 Cut out the template for 5K Dummy Trim


                                                          Lever

                                                          Rose
                                                          Liner

                                                          Hole drilled
                                                          through door
                                                          Washer
                                                          Machine screw


   Figure 2 Installing the dummy trim



T81177/Rev – 1911884 ER-7991-19 Aug 2005                         BEST ACCESS SYSTEMS
                                                              a Division of Stanley Security Solutions, Inc