Vinyl Decal Installation Guide
Take Your Time & Be Careful
Clean the surface thoroughly with rubbing alcohol; make sure that the surface is dry.
Center and the decal onto the surface where it will be installed. Use masking tape to hold
decal in place, use small pieces for the corners. Apply one piece of tape across the top, to
form a hinge.
With the decal in place carefully peel the back paper away. Hold bottom corners out and
down. DO NOT LET IT TOUCH THE SURFACE, YET!
With the decal on the prepared surface, and holding onto the bottom corners. Lightly
squeegee the decal onto the surface starting form the top center and squeegee down.
Repeat top down process and work out toward the edges. (This forces the air bubbles
out from the decal.) With the transfer tape still in place squeegee the entire decal firmly
to adhere the decal to the surface.
STEP 4 (this step does not apply to full color decals)
Gently peel the transfer tape away, leaving the letters in place.
To remove any existing air bubbles, carefully use a razor blade and gently puncture one
end of the air bubble, use the squeegee and push the air out towards the puncture area.
Repeat as necessary.
Contact A-1 Engraving & Signs if you have any problems or questions.