walker zanger stone by abe23

VIEWS: 77 PAGES: 2

									                       Vanity Installation Instructions for:
                                                    Alhambra Vanity
                                                    Gramercy Park Grand Vanity
                                                    Gramercy Park Petite Vanity
                                                    Savannah Vanity
                                                    Studio Washstand
   INSTALLATION TO BE PERFORMED BY A LICENSED CONTRACTOR OR PLUMBER ONLY

                                          INSTALLATION CHECKLIST
     1.   For rough-in guidelines, refer to the Specification Sheet for your specific vanity
     2.   Level vanity
     3.   Attaching under mount sink to top- instructions on page 2
     4.   Installing stone top onto base- instructions below
     5.   Sealing stone top- consult WZ Care and Maintenance Instructions sheet
     6.   Complete plumbing installation
     7.   Adjust hinges and grease drawer glides as required

  INSTALLING UNDER MOUNT SINK TO STONE VANITY TOP
                        What you will need: denatured alcohol, a pencil, and adhesive silicone.
                           You may also need: rubber mallet, drill, and a ¼” masonry bit.
                   NEVER use plumber’s putty or other oil-based products on natural stone.

1. Place stone top upside down on a flat, sturdy, level surface with padding between stone and work
surface to protect stone top.

2. Make sure your WZ stone and sink are clean and dry. Clean rim of sink and area around sink
opening with denatured alcohol for best watertight seal.

•   If your stone top has brass anchors already installed on the underside, skip to #5
•   If your stone top has been pre-drilled for brass anchors but the brass anchors are not installed, skip to #3
•   If you are working with a top that has not been pre-drilled for anchors, center sink over stone cutout, locate four points
about 1” from bowl rim (within open cabinet area and away from faucet holes), drill holes ¼” x ¼”, then proceed to #3.

3. Place a small amount of silicone adhesive in pre-drilled hole and press or gently tap inserts into
place inserting slotted end in first, so that anchor is fully imbedded into top and flush with surface.
Immediately remove excess adhesive from inside threaded anchor before adhesive dries.

4. Position sink upside down on top and center sink over stone cut out. Once final centered location
is determined, trace sink location in pencil on stone top.


DISCLAIMER: INSTALLATIONS INSTRUCTIONS PROVIDED BY WALKER ZANGER ARE GUIDELINES ONLY. FOLLOW
ALL LOCAL BUILDING CODES AND SAFETY CODES AND ONLY USE QUALIFIED LICENSED CONTRACTORS. WALKER
ZANGER IS NOT RESPONSIBLE FOR ANY DAMAGE OCCURING DURING OR AFTER INSTALLATION.

                                                             -1-
                     Installing Under Mount Sink to Vanity Top, cont.

5. Remove sink and apply a narrow continuous bead of silicone adhesive along top rim.

6. Position sink rim on stone within traced outline and press down to create a seal.

7. Mount hardware by first threading wing nut well up on screw near the head. See diagram.




                                          OR

8. With washer and slotted clip in place, tighten screw securely to lock into brass insert.

9. With bowl centered over cutout, hand-tighten wing nuts to secure bowl. Do not over tighten.

10. Immediately remove excess sealant from inside lip. Allow 24 hours for silicone to dry.




                 INSTALLATION OF STONE TOP ON BASE
*Mount sink to stone top prior to securing stone top to base. See detailed instructions
above before proceeding.

To secure top to console apply thin bead of silicone adhesive to top edge of console base.

Place stone top on console base and press firmly to create seal with adhesive. Check measurements of
top overlap on left and right to ensure top is centered on console base. Top should be flush in the
back, with a consistent overhang dimension on both sides and front.

Seal stone top prior to proceeding on to plumbing installation.




DISCLAIMER: INSTALLATIONS INSTRUCTIONS PROVIDED BY WALKER ZANGER ARE GUIDELINES ONLY. FOLLOW
ALL LOCAL BUILDING CODES AND SAFETY CODES AND ONLY USE QUALIFIED LICENSED CONTRACTORS. WALKER
ZANGER IS NOT RESPONSIBLE FOR ANY DAMAGE OCCURING DURING OR AFTER INSTALLATION.
                                                 -2-

								
To top