Docstoc

Pressure and Temperature Relief Valve RMC HT575

Document Sample
Pressure and Temperature Relief Valve RMC HT575 Powered By Docstoc
					Pressure and Temperature Relief Valve RMC HT575
Installation guide: (please see inside cover of box for further specifications and details)



       RMC valves should be installed by a licensed plumber

       If the temperature probe protruding from inside the inlet thread is damaged or bent, do not
        install – obtain a replacement valve.

       Clean out all deposits from the valve housing before fitting a replacement valve, otherwise
        the new valve risks contamination and premature failure.

       Apply PTFE thread tape to the male taper thread, making sure that the tape does not hang
        over the outer end of the thread, as this can lead to premature valve failure.

       Screw the valve into the heater socket. Do not use a wrench on the valve body.

       If the valve is positioned horizontally, the drain outlet must face vertically downwards.

       No valves, taps or other isolating devices are to be fitted between the Pressure and
        Temperature Relief valve and the water heater.

       Install the drain line to match the nominal size of the valve (as indicated under VALVE
        SPECIFICATIONS on inside cover of box)




        Level 19, 644 Chapel Street | Sth Yarra VIC 3141 | Direct: 03 9823 6271 | Fax: 03 9826 3642
                    service@siddonssolarstream.com | www.siddonssolarstream.com

				
DOCUMENT INFO
Shared By:
Categories:
Stats:
views:177
posted:4/3/2010
language:English
pages:1
Description: Pressure and Temperature Relief Valve RMC HT575