Docstoc

Instrument cluster test modes

Document Sample
Instrument cluster test modes Powered By Docstoc
					Instrument Cluster Test Modes
Test Gauge Sweep Fill in All LCD Indicator Bulbs ROM Level NVM Level DTC Road Speed MPH Road Speed KPH Engine Speed RPM Fuel Volume Engine Coolant Temp (not in Degrees) Battery Voltage ABS fail Electronic Brake Distribution (EBD) Failure Illumination Crank Sense Instrument Cluster Display GAGE 8888 buLb rXXX EXXX dtc NoNE / dtc XXXX XXX.X XXX.X XXXX FXXX XXXC bXXX Ab - [H / L] Eb - [H / L] IL - [H / L] Cr - [H / L] Gauge / Indicator / Display Tested All Analog Gauges LCD Odometer All Instrument panel Bulbs Instrument Cluster ROM Version NVRAM Version Diagnostic Trouble Codes Digital Speedometer Digital Speedometer Digital Tachometer Fuel Sender System Engine Coolant Sensor Battery Voltage ABS System EBD System Dash Illumination Crank Sensor Description Gauges sweep from left to right and back Tests all LCD Display Segments Illuminates all Warning Bulbs Display ROM Version Display NVRAM Version Press TRIP Reset repeatedly to view next DTC if present. Displays Speed in MPH Displays Speed in KPH Displays Engine Revolution Speed Displays Current Fuel Level Signal Displays Engine Temperature Signal Displays Battery Charge in Volts ABS Status EBD Status H=Dash Lights on / L=Dash Lights off Instrument Cluster Crank Sensor

DTC Codes
Code 1197 5284 9202 9204 9213 9232 9317 9318 9342 9356 9359 9364 9600 9601 Description Select / Reset Switch Failure Oil Pressure Switch Failure Fuel Sender Circuit Open Fuel Sender Circuit Short to Ground Anti-theft Number of programmed Keys is below Minimum Antenna not connected / defective Transceiver Battery Voltage High Battery Voltage Low ECU Error Ignition Run Circuit Open Engine Run / ACC Circuit Error Ignition Start Circuit Open PATS Ignition Key Transponder Signal is Not Received (Damaged Key or non-PATS Key) PATS Received Incorrect Key-Code from Ignition Key Transponder (unprogrammed Encoded Ignition Key) A139 A141 A143 A477 D027 D041 D043 D073 D123 D147 D262 9681 Code 9602 Description PATS Received Invalid Format of Key-Code From Ignition Key Transponder (Partial Key Code) PATS Tranceiver Signal is Not Received (Not Connected, Damaged, or Wiring) PCM ID does not match between Instrument Cluster and PCM NVM Configuration Failure (No PCM ID exchange between Instrument Cluster and PCM) Odometer Memory Failure Module Configuration Failure Missing / Invalid RPM Data Missing / Invalid Vehicle Speed Data Missing / Invalid Traction Control Data Missing / Invalid Coolant Temp Data Missing / Invalid Odometer Data Missing / Invalid Vehicle Security Data SCP Communication Bus Error


				
DOCUMENT INFO
Shared By:
Categories:
Tags:
Stats:
views:87
posted:2/1/2010
language:English
pages:1