How To Install The Vertical Blind
Fitting The Brackets
With these instructions you will find sufficient brackets and wood screws for fitting your blind.
Top Fix Brackets
Fix brackets to ceiling or lintel with holes drilled at least 3 inches (75mm) from the wall or window frame. For
blinds with 5inch (127mm) louvers or 2 1/8 inch (55mm) brackets for blinds with 3 ½ inch (89mm) louvers.
End brackets should be about 1 ½ inch (40mm) from the ends of the track. Any remaining brackets should be
placed evenly between these brackets.
Face Fix Brackets
Fix brackets to wall or window frame as closely as possible to the ceiling or lintel with same spacing as top fix
Fitting The Track
Track must be fitted into brackets keeping controls top side ordered.
Locate the small lip projecting from the brackets into the groove on the track. Push the track up into the
brackets. Spring clip brackets will hold your track without further adjustment. If your brackets have retaining
screws these should now be screwed into the other slot in the track.(DO NOT OVER TIGHTEN THE
SCREWS. THIS IS UNECESSARY AND WILL DAMAGE THE TRACK.)
Fitting The Louvers
Turn hooks so that the slots are 180 degrees to the track.
Hang louvers keeping all seams one way. Your blinds is now ready to operate.
IMPORTANT: DO NOT TRAVERSE BLINDS WITH THE LOUVERS IN A CLOSED POSITION.
ALWAYS TURN THEM 90 DEGREES TO THE TRACK OPERATING CORD CONTROL