Documents
Resources
Learning Center
Upload
Plans & pricing Sign in
Sign Out

Safety Practices for Lifting Products

VIEWS: 1 PAGES: 1

working near water working over water safety working near or over water heavy equipment safety inspecting lifting products sop safe fueling of products

More Info
									          Safety Practices for Lifting
                   Products
                                              FIBER ROPE
1.            Never drag a rope. This hurts the outer fibers and leads to the eventual deterioration
of the rope's overall strength.
2.            Avoid kinking. This strains the rope and overstresses the fibers.
3.            Splice, don't knot. When the job requires joining lengths of ropes, they should be
spliced, not knotted. A properly done splice will hold up 100% of the strength of the rope, but a
knot only half.
4.            Dry out rope after use to prevent deterioration.
5.            Don't allow rope to freeze.
6.            Store away from heat, moisture, chemicals, rodents, and sunlight.
7.            Clean rope before storage.


                                             WIRE ROPE
1.           Use sheaves and drums of suitable size and design.
2.           Lubricate properly, and according to schedule.
3.           Don't exceed the rated capacity of wire rope.
4.           Be sure to use the correct lay (twist) for the application.

                                               CHAINS
1.           Take up slack slowly and make sure every link seats correctly.
2.           Never force a hook over a chain link.
3.           Chain shackles are to be used for shortening and/or splicing chains together.
4.           Using bolts as makeshift links or fasteners is prohibited.

                                     CHAIN/WIRE ROPE MOTORS
1._Make sure your hoist anchor point is rated and adequate for the job.
2._Always inspect the hoist for defects before each use. Check the full length of the chain for worn,
gouged, twisted and distorted links, proper lubrication and foreign material.
3._Check the full length of the wire rope for broken strands, abrasions, kinks, and corrosion.
4._Do not operate hoist with twisted, kinked, or damaged chain or rope.
5._Check the limit switch settings prior to loading. Operate the hoist in the up and down position
to determine if the limit switches are set correctly.
6._Make a load test by lifting and lowering a load slightly. Check for unusual sounds and make sure
the hoist is operating smoothly and that the brakes hold without slipping.
7._Do not lift more than the rated load.
8._Always center the hoist over the load. Be sure the hoist and load chain are in a straight line.
9. _Always stand completely clear of the load when operating a hoist.

								
To top