How to Build a Mini-Robot Wars Robot
1. Lines are where the metal will be folded and only mark the centres of the
holes.
Error! Unknown character in picture string. Page 1 23/09/2008
2. Punch all holes before you bend the sheet.Bend the sheets to the angles
shown.
3. Strip the motor gear boxes and bolt the gear box cases to the base plate.
Error! Unknown character in picture string. Page 2 23/09/2008
4. Cut the gear box axles to the required lengths.
5. Reassemble the gear boxes with the long side of the axles to the outside.
Error! Unknown character in picture string. Page 3 23/09/2008
6. Carefully fit the wheels to the axles (two wheels to each axle).
7. Fit the connector block in the centre of the base as shown and carefully
connect the wiring harness to the motors. You will need help with this so wait
until you are shown how to do it correctly. (The motors can be easily
damaged).
8. Fit the top in place with two nuts and bolts.
9. Pass the wiring harness through the large hole in the centre of the Top Plate
and fit the aerial rod through the small hole and attach the wiring harness to
the pole with tape.
Error! Unknown character in picture string. Page 4 23/09/2008
10. The control panel must now be assembled and fitted to the other end of the
wiring harness. This must be done with very great care as the switches and
the board can be easily damaged with overheating from the soldering iron, so
wait for instructions.
Error! Unknown character in picture string. Page 5 23/09/2008