CapriSun Pouch Checkbook Making crafts out of Capri Sun or

Document Sample
CapriSun Pouch Checkbook Making crafts out of Capri Sun or Powered By Docstoc
					                                    CapriSun Pouch Checkbook

Making crafts out of Capri Sun or KoolAid Jammer pouches can be a lot of fun. You can make cool and
durable gifts. Below are instructions for making a checkbook cover that I made.

Here's what you'll need:

      6 empty caprisun/kool-aid Jammer juice pouches
      X-acto knife
      Sewing machine
      Thread
      Scrap fabric
      Clear thick vinyl

Note: The little diagrams on the right are not exactly to scale, so your checkbook cover may look a
little different.


                 1: After the juice has been emptied (drank) use an x-acto knife to slit the bottom of
                 the juice pouch. Clean the inside of each pouch with hot soapy water and let dry.
                 Using the x-acto knife cut the back silver part of the Capri Sun off of the front, leave
                 the seam attached to the front for stability. Discard the back silver part of the

                 2: Sew two pouches together side by side overlapping so it is not too wide for the
                 check book. When sewing it is best to do a back stitch to increase the strength of
                 the wallet. Sew two more together overlapped to make the same width as the first
3: Now sew all four together.

4: Measure the length and width of the four pouches. Find a piece of fabric and cut
it a little larger than those measurements for a hem. Hem the fabric, once it is
hemmed it should have the same measurements as the four pouches sewn together.
Now sew the lining to the inside part of the pouches.

5: On one end fold 1 inch over to the inside and sew, this is a hem.

6: Then fold approximately 2 3/4 inches inward again. This will show you the size
your checkbook cover/wallet will be, make sure you check book fits within this
before you sew it, make adjustments in how much this is folded if needed. But do
not sew yet.

7: Take your last two juice pouches with back removed and cut approximately 2
3/4" off the top of both of them and sew those together at the same width as
everything else (approximately 6 3/4 inches). With the leftover ends of the two
pouches cut one 1 3/4" and another 1 1/8". Sew the 1 1/8" to the 1 3/4" strip, lining
up the two bottoms and sewing the bottom and the two sides leaving the top end
open. Now sew this piece to the end that is folded inward, sew it close to the fold
rather than the end where the opening of the pocket will be. This will be used as a
card holder. You want the opening to face the middle of the wallet.

8: Take the clear vinyl and cut it in a rectangle 4" by 2 1/2" Sew the clear vinyl to
the piece measuring approx. 2 2/3" by 6 3/4" leaving one end open.
                 9: Sew the bottom and two sides of this piece to the wallet having the opening of
                 the clear vinyl face the middle of the wallet. This is your first pocket.

                 10: You can now fold the other side of the wallet inward and sew the two sides
                 down, this is your second pocket. Now your checkbook cover/wallet is finished!
                 Crafts made out of caprisun/ kool-aid jammer juice pouches are fashionable with the
                 extra bonus of being recycled.

About The Author:
Stella contributes craft ideas to If you have any craft ideas that you would like to
share with Stella and ThriftyFun community, please submit them here.

Shared By: