Heat reflective panels to save on heating by ridwan.kurniawan87

VIEWS: 32 PAGES: 3

									          Heat reflective panels to save on heating
A quick and easy method to limit the large dispersions of heat through the outer walls, is the use
                            of heat reflective panels behind the radiators.




                            Save money on heating




With the arrival of the problem back on power bills for the radiators in the house, those who have
this classical system of heating, however, to help reduce heat loss in a simple and also quite fast
and inexpensive, can use of heat-reflecting panels,to be positioned just behind the radiators
themselves.

If the building is not isolated in an appropriate manner, a part of the heat produced by the heating
very often goes dispersed, especially if the radiators are leaning towards the outer walls,causing
also wheelies significant in energy bills. Whether new construction often this problem is solved, as
well as the proper insulation of the building, with specific actions, aimed at solving these
problems. For example, are inserted polyurethane panels, also with a network port plaster ,
for final finishing, which act as their own by thermo reflective of heat transmitted through the
radiator. dated In homes, it is difficult to present a similar solution for the heat insulation , so it is
very common, especially where no interventions were made subsequent targeted to reduce
dispersion, have radiators under windows, which dissipate a lot of heat through the external
walls.
                Thermo reflective panels for radiators




The heat reflective panels to be positioned behind the radiators are characterized by a structure
in expanded polyethylene , or an insulating material, heat resistant, flame retardant and also
non-toxic, and by a sheet of aluminum that thanks to its silver surface, constituted by a very thin
film, acts precisely by heat reflector, allowing, in many cases, to push the heat of the heater
towards the inside of the house. panels thermo reflective for the radiators should be
arranged behind the radiator, precisely in the wall portion which occupies with its encumbrance
that often them encompasses and contains them. Thanks to these systems, simple and inexpensive,
the radiators can improve their efficiency by about 10% , even with a considerable saving. panels
thermo reflective, often also used for the isolation of the roof system, are a good system thermal
insulation which exploits the capacity thermo reflective surfaces of low emissivity, consist of
materials ranging ie to act so as to reduce the energy transmitted by radiation, by moving towards
the.
                               Advantages thermo panel




The thermo reflective panel for radiators brings many advantages in the home, in fact, going
to isolate the radiator from the first support wall , thus limiting losses and increasing the heat in
the rooms, so that heat up even faster and with a reduction of costs not irrelevant.
The same applies to the post heating; once the temperature is reached, the heat inside the
environment lasts    longer,thereby     limiting   further   consumption. On    the   market    there
arenumerous types of heat reflective panels for radiators, some of which sold well in practical
DIY kit , which allows for installation in full autonomy and with a few easy steps. Some types of
panels can also be cut to measure and in some cases ordering via internet , communicating, at
the time purchase, the measures of their radiators. In other cases, the panels must be purchased
directly in rolls, such as those of Three Emme srl , with costs around 7-9 euro per square
meter, and then can be cut into faidate, through the use of a cutter or a pair of solid steel
scissors. As for the bonding, it can use a double-sided rather strong, or the liquid glue to water,
or, finally, for those who want to try, even with the tacks from the wall. Another system for
positioning the panels thermo reflective, can be the 'Using a transparent nylon thread , slipped
on the edge of the surface of the panel, then to be fixed to the supporting brackets of the radiators,
having of course care to address the silver part aluminum towards the interior of the
room. With these systems, also thanks to an accurate control of the measures, the operations of
cutting and positioning, no problem will arise from the aesthetic point of view, because the panels
will remain hidden from the radiator.

								
To top