Quartet ARC3018 Magnetic Aluminum Whiteboard - 30x18 ARC Board Mounting Instructions

							http://www.monomachines.com/




                                                                                                                              Mounting Instructions
                                      Drywall Applications:
                                                                                               2"

                                         2"
                                                                                   1-1/4"


                                   4"
                               1-1/


                                                                  n
                                                      Lo     catio                           7/32"
                                               B oard                                       Drill Bit




                                        1.                                                                   2.
                                      Determine board location. To position top hanging brackets,           Insert screws through hanging brackets into the wall anchors.
                                      mark center hole of hanger 2" from outside edge of board and          Tighten firmly. Holding the board at an angle, place the channel
                                      1-1/4" from top of board. Drill holes for each hanger in marked       in the back of the frame over the wall hangers. Lower the board
                                      locations using a 7/32" drill bit. Insert wall anchors into holes     so it is flush to the wall. Note: if board is not level, hanging
                                      flush with the wall.                                                  bracket height can be adjusted by loosening the bracket
                                                                                                            mounting screw, sliding the bracket up or down, and
                                                                                                            re-tightening the screw.



                                      Cubical Wall Applications:                                           Optional Mounting (14” x 11” Board Only):

                                                                                                                                pads
                                                                                                                        stick                               nets
                                                                                                                  self-                                mag




                                                        k)
                                                   (bac
                                                                                                                                k)
                                                                                                                            (bac                           (bac
                                                                                                                                                                k)




                                                                                                           Self-Stick Pads:
                                        1.                                                                 Break apart adhesive pads into separate pieces. Peel off
                                      Insert pin through each mounting bracket until it snaps into         protective paper from one side of double-sided adhesive pad
                                      place. Remove protective paper from self-stick pads on               and apply to back of aluminum frame. Repeat for remaining
                                      mounting brackets. Insert brackets into channel in back of frame     pads. Remove remaining protective paper from each pad and
                                      so they are evenly spaced apart and press self-stick pads to back    install board on clean, dry surface. Press firmly in place.
                                      of board. Insert pins into cubicle wall in desired board location.
                                                                                                           Magnets:
                                                                                                           Use both the adhesive pads and magnets. Attach adhesive pads to
                                                                                                           aluminum frame following Self-Stick Pads instructions. After
                                                                                                           attaching pads to the back of the frame, remove remaining
                                                                                                           protective paper from pads and attach one magnet to each, adhering
                                                                                                           “tape” side to Self-Stick Pads. Hang board on any metal surface.

                                                                                                                                                               Arc_Com_inx_REV1




                                                                          For More Info

                                                                          Click Here --->




http://www.monomachines.com/