Defacer Eraser® Graffiti Wipe Paint, Coating & Graffiti Removers
Specifier Note: The information provided below is intended to guide the Architect in developing
specifications for products manufactured by PROSOCO, Inc. and should not be viewed as a
complete source of information about the product(s). The Architect should always refer to the
Product Data Sheet and MSDS for additional recommendations and for safety information.
Specifier Note: Paragraph below is for PART 1 GENERAL, Quality Assurance.
Test a minimum 4 ft. by 4 ft. area on each type of masonry. Use manufacturer’s application
instructions. Let the test panel dry 3 to 7 days before inspection. Use manufacturer’s application
instructions. Keep test panels available for comparison throughout the cleaning project.
Specifier Note: Paragraphs below are for PART 2 PRODUCTS, Manufacturers and Products.
Manufacturer: PROSOCO, Inc., 3741 Greenway Circle, Lawrence, KS 66046. Phone: (800) 255-
4255; Fax: (785) 830-9797. E-mail: CustomerCare@prosoco.com
Defacer Eraser Graffiti Wipe is a solvent-based product that removes a variety of graffiti stains
from most smooth masonry, split-faced concrete block, wood and metal surfaces. Graffiti Wipe is
an easy-to-use graffiti remover that does not contain methanol, methylene chloride or other
halogenated solvents prohibited on many projects.
FORM: Clear liquid with sweet almond odor
SPECIFIC GRAVITY: 1.04
WT/GAL: 8.69 lbvs
ACTIVE CONTENT: NA
TOTAL SOLIDS: NA
FLASH POINT: >200 degrees F (>93 degrees C) (ASTM D 3278)
FREEZE POINT: NA
SHELF LIFE: 2 years
MAXIMUM VOC CONTENT: 30%
• Product efficiency is reduced during cold weather.
• May damage synthetic or reflective glass.
Specifier Note: Paragraphs below are for PART 3 EXECUTION, Installation.
Before applying, read “Protect” and “Precautionary Measures” sections in the Manufacturer’s
Product Data Sheet for Graffiti Wipe. Do not dilute or alter. Avoid generating aerosol mists during
Smooth or Protected Surface Application
1. Apply Graffiti Wipe liberally to a towel or piece of cloth. Scrub the surface with saturated cloth
until the graffiti is removed.
2. Wipe the surface with a dry cloth to remove excess Graffiti Wipe and graffiti residue. If
necessary, rinse the surface with hot or cold water to remove any remaining product residue.
Rough/Porous or Unprotected Surface Application
1. Apply Graffiti Wipe with a brush or low-pressure spray.
2. Allow to dwell for 3-5 minutes.
3. Pressure-water rinse. Hot water is preferable.