Material Safety Data Sheet
Page 1 of 2
Distributor: Advanced Document Systems & Supply, Inc.
701 E Gardena Blvd
Gardena, California 90278
Manufacturer: The General Graphic Company
2525 Mandela Parkway
Oakland, California 94607
Prepared: 5-22-87 Updated: 06-96
I Product Identification
Generic ID: Complex Solvent Blend
DOT Shipping Name: Compounds, Cleaning, Liquid (Naphtha Solvent)
DOT Hazard Class: Combustible Liquid, NA1993
Trade Name: Rubber Rejuvenator
II Hazardous Components
Ingredient CAS Number WT% TLV(ppm)
Ethylene Glycol Propyl Ether 2807-30-9 ----- -----
Toluene 108-88-3 100 100
Methylene Chloride 75-09-2 100 100
Methanol 67-56-1 200 200
Cyclohexane 110-87-7 300 300
Methyl isobutyl Ketone 108-1-1 50 50
MethyIcyclohexane 108-87-2 400 400
N-Heptane 142-82-5 400 400
III Physical Data
Boiling Point: 112°F
Specific Gravity: 0.966
Vapor Pressure (mmHg at 200 C): 215
Evaporation Rate (N-Butyl Acetate = 1): > 1
Specific Vapor Density (Air = 1): > 1
Volatile Organic Content (VOC): 539 g/1 or 4.48 lb./gal
IV Fire & Explosion Data
Flash Point (TCC): > 100°F
Extinguishing Media: Foam, Water Fog, Carbon Dioxide, Dry Chemical. Rubber Rejuvenator Page 2 of 2
Special Firefighting Procedures: Wear self contained breathing apparatus with a full
facepiece. Keep containers cool with water spray.
Unusual Fire & Explosion Hazards: Vapors are heavier than air and may travel along
floor to ignition source.
V Health Hazard Data
Effects of Acute Overexposure
Eyes: Can cause irritation, redness, tearing, blurred vision.
Skin: Can cause irritation, defatting, dermatitis.
Inhalation: Nasal and respiratory irritation.
Swallowing: Can cause gastrointestinal irritation, nausea, vomiting and
Eyes: Flush with water lifting upper and lower lids. Get medical
Skin: Wash exposed area with soap and water.
Inhaled: Remove to fresh air. Give oxygen or artificial respiration as
required. Get Medical Attention.
Swallowed: DO NOT induce vomiting. Get medical attention.
Chronic Effects of Overexposure
Cardiovascular stress. May effect liver, kidneys and respiratory system.
VI Reactivity Data
Hazardous Polymerization: Will not occur.
Incompatibility (Avoid Contact With): Strong oxidizing agents.
VII Spill or Leak Procedures
Spill Procedures: Eliminate all ignition sources. Clean with absorbent materials and place
in closed containers for waste disposal.
Waste Disposal: Consult Federal, State and Local disposal authorities for approved
VIll Special Protection & Precautions
Respiratory Protection: Approved organic vapor type respirator if TLV (or PEL) values
Ventilation: Provide ventilation to maintain safe exposure levels.
Protective Gloves: Wear resistant gloves such as: Neoprene rubber.
Eye Protection: Chemical splash goggles in compliance with OSHA regulations.
Other Protective Equipment: Wear impervious clothing if desired.
Comments: Containers of this material may be hazardous when empty. Since empty
containers retain product residues (vapor, liquid and/or solid), all hazard
precautions in this datasheet must be observed.