change ip by propratixa


Cable Modem IP Hijacking in Win95/98

The purpose of this is to show you how bad cable modems security is and that
even with a win box you can take someone else's IP. You can hijack IP's using
a cable modem and it's very simple in any operating system. Just follow the

1) Choose someone's IP that you wish to have. Make sure the IP is on the same
network. Most cable modem providers use DHCP. The fist thing you have to
do is find the victims IP. Remember the victims IP has to be in the same
network and with the same service provider for this to work.

2) Now this is probably the hardest thing in this file (but it's still easy),
you have to wait until the victims computer is off or you can Smurf kill
his connection. When you think his computer is off-line just try to ping
it to see if you get a response. Do this by going to a DOS prompt and
typing "ping ". If you get a response then you have to try

After you get his PC off-line then you go into your network properties and
edit the IP settings, but instead of having yours there you put the victims
IP, host, and domain.

3) Restart. If you restart and you get an IP conflict this means that the
victims computer is on, if you don't get an IP conflict then try to go to
your web browser and see if it works. With some cable modem providers you
might have to also add the Gateway, Subnet mask (, Host, DNS
search, and Domain.

Now you can go. Everything will work until the victims PC is back on. Once it is
back online it will take the IP away because it will tell you that you have the
wrong Mac addresses.

This is also possible in Linux, but is not the best way. You can change your Mac
address to the victims PC and this is more secure and much easier. There are a
couple of scripts to change your address, just look around.

Warning: Some cable modem service providers will know when you're using the wrong
IP, but hey

More Info
									Change Your Ip In Less Then 1 Minute

1. Click on "Start" in the bottom left hand corner of screen
2. Click on "Run"
3. Type in "command" and hit ok
You should now be at an MSDOS prompt screen.
4. Type "ipconfig /release" just like that, and hit "enter"
5. Type "exit" and leave the prompt
6. Right-click on "Network Places" or "My Network Places" on your
7. Click on "properties"
You should now be on a screen with something titled "Local Area
Connection", or something close to that, and, if you have a network
hooked up, all of your other networks.
8. Right click on "Local Area Connection" and click "properties"
9. Double-click on the "Internet Protocol (TCP/IP)" from the list under
the "General" tab
10. Click on "Use the following IP address" under the "General" tab
11. Create an IP address (It doesn't matter what it is. I just type 1 and
2 until i fill the area up).
12. Press "Tab" and it should automatically fill in the "Subnet Mask"
section with default numbers.
13. Hit the "Ok" button here
14. Hit the "Ok" button again
You should now be back to the "Local Area Connection" screen.
15. Right-click back on "Local Area Connection" and go to properties
16. Go back to the "TCP/IP" settings
17. This time, select "Obtain an IP address automatically"
tongue.gif 18. Hit "Ok"
19. Hit "Ok" again
20. You now have a new IP address
With a little practice, you can easily get this process down to 15

This only changes your dynamic IP address, not your ISP/IP address. If
you plan on hacking a website with this trick be extremely careful,
because if they try a little, they can trace it back

To top