SYSTEM5/8 8-Ohm 01 0104.5 - LAY-IN CEILING MOUNT (TILE REPLACEMENT) LOUDSPEAKER ASSEMBLIES GENERAL DESCRIPTION AUDIO SPECIFICATIONS: The SYSTEM5/8 is a complete loudspeaker assembly with a 8” Average Sensitivity 92 dB-SPL, 1W/ 1M O.D. full range speaker, perforated steel baffle, and integral Loudspeaker Power 12W RMS, EIA 426A Standard molded fiber enclosure; one 24" white "T" bar supplied to finish Rating edge. Nominal impedance is 8-Ohms. Calculated Maximum 103dB-SPL, 12W / 1M Finish: Baked epoxy hybrid System Output Magnet Type, Weight BeFe Ceramic, 4.8 oz. Nominal INTENDED USE Frequency Response 65 Hz - 17 kHz Indoor environment, mounted parallel to floor plane in a 24” EIA 426A Standard wide suspended ceiling tile grid. Nominal 100° Included angle, -6dB Program Material: Signal tones, voice and music. Coverage Angle 2 kHz, half space UL Listed 1480- ( UEAY, UEAY7-Canada ) Audio 7” long labeled, tinned As a General Signaling Device: when installed in accordance Connection wires, pre-cut with supplied installation instructions, requirements of NEC and AHJ. Recommended construction sequences, installation instructions, A&E Guide Specifications, EASE .GLL / .CF2 files, are available CITY of CHICAGO APPROVED- Material and construction on the web at: permits use where ceiling plenum is part of the air handling sys- www.QuamSpeakers.com/support-pages/ae-resources.shtml tem. SYSTEM COMPONENT Loudspeaker 8C5PAX FINISH OPTIONS White Order as SYSTEM5/8 Black Order as SYSTEM5/8/B Quam-Nichols Distributed By: LU LEE DAN COMMUNICATIONS, INC. www.leedan.com firstname.lastname@example.org IBEW 1031 Toll-Free 1-800-231-1414 91H1 Since 1930 © 2012 Quam-Nichols Company Quam-Nichols reserves the right to make changes and/or improvements to its products at any time and without notice. TSYSTEM5/8_12FE20 INSTALLATION INSTRUCTIONS 12– 2.20 8089 (1’ x 2’) SYSTEM 5 – includes 8-Ohm, /25RS and /70RS versions (2’ x 2’) SYSTEM 12 – includes 8-Ohm, /25RS and /70RS versions INTENDED USE: All versions: Indoor environment, mounted parallel to floor 3. Remove cable /conduit clamp fitting from plate; plane in a 24” wide, suspended ceiling tile grid; mount height Install UL Listed metallic enclosure entry fitting for 18’ or less above floor plane. plenum cable or flex whip. Program material: Signal tones, voice and music. 4. Feed supply cable through whip to connector. Make connections per wiring diagrams below; Insulate all unused taps from each other, the enclosure UL Listed 1480 and electrical ground. City of Chicago Approved “ Material and construction permits use When cover plate is secured, all connections / splices and where ceiling plenum is part of the air unused leads must be inside of the enclosure. handling system” 91H1 5. Place assembly onto ceiling grid, install 24” T-bar Type G– General Signaling trim piece where required (furnished only with specific TYPE G 1’x2’ formats). 1. Cut ceiling tile as required: 1’ x 2’ FORMAT LOUDSPEAKER NOTE! AHJ/ local codes may require tie-off to structure. 2’ x 2’ tile – Cut tile in half along one axis. Bend up tie-off tabs as shown in illustration and install as 2’ x 4’ tile – Cut 12” from edge along 2’ axis and directed. discard smaller piece. 2’ x 2’ FORMAT LOUDSPEAKER NOTE! AHJ/ local codes may require tie-down to grid. 2’ x 2’ tile – No cutting required. Recommended fasteners; not supplied: Erico/Caddy part 2’ x 4’ tile – Cut tile in half along 2’ axis. ATA4i and 1/4”-20 x 2” bolt, or equivalent. Install as directed. ! Steps 2-3 – Required only if using conduit clamp 6. Place remaining ceiling tile into opening as required. fitting other than what is provided with product. Tie-off 2. Loosen, but do not remove screws on cover plate; tab 4x push up and remove plate from assembly. RED Tie-off Tie-off tab 2x tab 2x 8Ω BLACK ( Common ) QUAM 8-Ohm Operation 4W Brown 5W @ 25V only 2W Red 2.5W @ 25V only Orange 1.25W @ 25V only 1W RED Green 0.63W @ 25V or 5W @ 70.7V 8Ω White 0.32W @ 25V or 2.5W @ 70.7V 8Ω Blue only 1.25W @ 70.7V 0.5W Gray only 0.63W @ 70.7V OFF Violet only 0.32W @ 70.7V 0.25W BLACK ( Common ) BLACK ( Common ) QUAM Model TBLU QUAM /25RS and /70RS Rotary Select Distributed By: LEE DAN COMMUNICATIONS, INC. www.leedan.com email@example.com Toll-Free 1-800-231-1414 © 2012 Quam-Nichols Company Quam-Nichols reserves the right to make changes and/or improvements to its products at any time and without notice.
Pages to are hidden for
"QUAM SYSTEM5/8 8-Ohm Lay-In Ceiling Mount Loudspeaker Assembly"Please download to view full document