Docstoc

tandberg 770-880-990

Document Sample
tandberg 770-880-990 Powered By Docstoc
					          INTEGRATION INSTRUCTIONS
               FS-03 TO VIDEO CODEC                                                                     Tandberg
                                                                                                       770,880,990
STEPS:
 1. Connect microphones and speakers to the FS-03
2. Connect the codec as shown in FIG. 1



                                                                                                                             FIG. 1

                                                                                                        CTG CABLE:C-111
                     Tandberg Audio Connections
                                                                                                        CTG CABLE:C-112



                                                                        to codec      from codec




  3. The Tandberg onscreen audio menu has selections to enable/disable inputs and outputs. Audio output #1 and audio input #4
      should be enabled. The menu also has level adjustments for audio in & out. Initially these should be set at about mid-range.
  4. Setting the audio send level
              There are two send level settings requiring adjustment during setup:                                   Adjust the microphone send
                        The onscreen audio-input level on the Tandberg.                                              level by raising (clockwise)
                        The “to codec” trim pot on the FS-03 FIG. 2                                                  the “to codec” trim pot on the
                                                                                                                     FS-03
  5. Setting the audio receive levels                                                              FIG. 2
              There are four receive level settings for the incoming audio:
                        The onscreen speaker level accessed with the codec remote control.
                        The onscreen audio output #1 level.
                        The speaker volume knob on the front of the FS-03
                        The “from codec” trim pot on the back of the FS-03
      • With the Tandberg remote set the onscreen volume to mid-range (this will allow users room to adjust their desired levels).
      • Turn the speaker volume on the front of the FS-03 to the 1:00 position. FIG. 3

                                                                                                   Speaker volume   FIG. 3

      • Adjust the onscreen audio input level on the Tandberg and the “from codec” trim pot on the back of the FS-03 to comfort-
        able listening levels. To minimize amplifying noise the higher-level setting should be at the FS-03 FIG. 4


                                                                                                                    FIG. 4

      For optimum echo cancellation send and receive levels should be fairly equal. Levels at the speakers should not be set so high
      that the audio from distant participants is louder than people speaking in the room.

      Note:   For rooms with a high amount of ambient noise, we recommend the Automatic Gain Control (AGC) in the Tandberg
              be turned OFF.

      Free CTG tech support is available to assist you with these calibrations via audio or video call.
                                       PHONE: 904-880-5125
                                       VIDEO: ISDN (128k) 904-886-9578
                                              IP (192k) 68.153.227.231
                                       EMAIL: support@ctgaudio.com

				
DOCUMENT INFO
Shared By:
Tags: tandberg
Stats:
views:122
posted:4/21/2012
language:English
pages:1
Description: INTEGRATION INSTRUCTIONS FS-03 TO VIDEO CODEC
megaphonegm megaphonegm
About