Document Sample
1574001pdf Powered By Docstoc
					- - - - - - - - - - - - - - - - MATERIAL SAFETY DATA SHEET - - - - - - - - - - - - - - Kreso
----------------------------------------------------------SECTION I ----------------------------------------------------------MANUFACTURER'S NAME: KRESO INC. P.O. BOX 6745 ELMWOOD PARK ST. OMAHA, NE 68106 EMERGENCY TELEPHONE NO.: 402-551-5133 EMERGENCY: CONTACT CHEMTREC 1-800-424-9300 CHEMICAL NAME AND SYNONYMS: Coal Tar Product TRADE NAME AND SYNONYMS: Kreso(R) Dip #1 CHEMICAL FAMILY: Coal Tar phenols FORMULA: See label ----------------------------------------------------------SECTION II - HAZARDOUS INGREDIENTS ----------------------------------------------------------PAINTS, PRESERVATIVES, & SOLVENTS % TLV (Units) ----------------------------------------------------------PIGMENTS CATALYST VEHICLE SOLVENTS ADDITIVES OTHERS ----------------------------------------------------------ALLOYS AND METALLIC COATINGS % TLV (Units) ----------------------------------------------------------BASE METAL ALLOYS METALLIC COATINGS FILLER METAL PLUS COATING OR CORE FLUX OTHERS ----------------------------------------------------------HAZARDOUS MIXTURES OF OTHER LIQUIDS, SOLIDS OR GASES % TLV (Units) ----------------------------------------------------------Coal Tar Phenols 18 5ppm Coal Tar Hydrocarbons 53 100ppm ----------------------------------------------------------SECTION III - PHYSICAL DATA ----------------------------------------------------------BOILING POINT (deg F.): 425 F VAPOR PRESSURE (mm Hg.): 760 VAPOR DENSITY (AIR = 1): N/A SOLUBILITY IN WATER: Freely SPECIFIC GRAVITY (H2O = 1): 1.025 PERCENT, VOLATILE BY VOLUME (%): No data EVAPORATION RATE (Butyl Ac = 1): 1 APPEARANCE AND ODOR: Dark low viscosity liquid with cresylic odor ----------------------------------------------------------SECTION IV - FIRE AND EXPLOSION HAZARD DATA ----------------------------------------------------------FLASH POINT (Method used): 175 F TCC FLAMMABLE LIMITS: Not available LEL: UEL: EXTINGUISHING MEDIA: Water, fog, foam, CO2, dry chemical SPECIAL FIRE FIGHTING PROCEDURES: Wear full protective clothing, do not allow any exposed body surface. Flammable, toxic vapors given off in a fire. Use selfcontained breathing apparatus. UNUSUAL FIRE AND EXPLOSION HAZARDS: Closed containers can build up pressure if exposed to heat. Water can be used to cool containers.

----------------------------------------------------------SECTION V - HEALTH HAZARD DATA ----------------------------------------------------------THRESHOLD LIMIT VALUE: See Section II EFFECTS OF OVEREXPOSURE: Vapors cause irritation to eyes, nose and throat. Rapidly absorbed through skin. Contact with skin or eyes causes severe burns. EMERGENCY AND FIRST AID PROCEDURES: INHALATION: Remove to fresh air. SKIN AND/OR EYE CONTACT: Flush immediately with plenty of water for at least 15 minutes. Remove contaminated clothing and shoes immediately. Call a physician. Wash clothing before reuse. Discard shoes. ----------------------------------------------------------SECTION VI - REACTIVITY DATA ----------------------------------------------------------STABILITY: Stable CONDITIONS TO AVOID: INCOMPATIBILITY (Materials to avoid): Avoid contact with strong oxidizing agents. HAZARDOUS DECOMPOSITION PRODUCTS: None HAZARDOUS POLYMERIZATION: Will Not Occur CONDITIONS TO AVOID: ----------------------------------------------------------SECTION VII - SPILL OR LEAK PROCEDURES ----------------------------------------------------------STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Remove sources of ignition. Avoid breathing vapors. Avoid contact of eyes or skin with vapor or liquid. Absorb spills with sand, dirt or industrial absorbant. Use protective measures outlined in Section VIII below. WASTE DISPOSAL METHOD: Use either approved sanitary landfill or incineration. (Do not incinerate closed containers.) Disposal must be carried out in accordance with local, state and federal regulations. ----------------------------------------------------------SECTION VIII - SPECIAL PROTECTION INFORMATION ----------------------------------------------------------RESPIRATORY PROTECTION (Specify type): NIOSH certified Organic Vapor Canister Unit VENTILATION: LOCAL EXHAUST: Use adequate ventilation to keep vapor and flammable concentrations below their listed values (TLV) UEL and LEL unknown MECHANICAL (General): SPECIAL: OTHER: PROTECTIVE GLOVES: Rubber or Neoprene EYE PROTECTION: Chemical Safety goggles; Face shield OTHER PROTECTIVE EQUIPMENT: Coveralls and/or rubber apron. Rubber shoes and boots. ----------------------------------------------------------SECTION IX - SPECIAL PRECAUTIONS ----------------------------------------------------------PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: Store in tightly closed, properly labeled containers. Avoid prolonged and/or repeated contact with skin. do not take internally. NIOSH certified canisters can be used if oxygen level is above 19.5% or vapor level is below 2%. Otherwise use self contained units. OTHER PRECAUTIONS:

Page 1 of 2

- - - - - - - - - - - - - - - - MATERIAL SAFETY DATA SHEET - - - - - - - - - - - - - - Kreso
----------------------------------------------------------This information is furnished without warranty, representation or license of any kind, except that it is accurate to the best of Kreso, Inc. knowledge or obtained from sources believed to be accurate. Kreso, Inc. does not assume any legal responsibility for use or reliance upon same. BEFORE USING PRODUCT READ ITS LABEL. ----------------------------------------------------------DISCLAIMER OF EXPRESSED AND IMPLIED WARRANTIES: Although reasonable care has been taken in the preparation of this document, we extend no warranties and make no representation as to the accuracy or completeness of the information contained therein, and assume no responsibility regarding the suitability of this information for the user's intended purposes or for the consequences of its use. Each individual should make a determination as to the suitability of the information for their particular purpose(s). A request has been made to the manufacturer to approve the contents of this material safety data sheet. Upon receipt a new MSDS will be made available. ----------------------------------------------------------COMPAS Code: 15740010


Page 2 of 2

Shared By: